Home > Help Center > FAQ
Disassembly and assembly of main menbers

1. Die platen

Disassembly: draw “powder baffle” out, take “feeding hopper” down, screw “feeder setscrew” out, screw “feeder set stud” and “spring” off, take “feeder” down, and screw “die platen setscrew” off, so as to take “dis platen” down.
Assembly: conduct in reverse order as above. Align inscrewing “feeder setscrew” for fear of danaging the threaded hole of feeder. Fix “feeder set stud” in the groove when fastening “feeder setscrew”.


2. Upper punch

Disassembly: unscrew “connecting rod nut”, clockwise rotate “upper plunger” to make it out of “connecting rod”, rotate “handwheel” to make “eccentric wheel sleeve” up to the top, and then rotate “eccentric wheel sleeve” to vibrate “connecting rod” in front upper, so as to take “upper punch” out of the upper of “platen base” hole.
Assembly: conduct in reverse order as above.


3. Lower punch

Disassembly: screw “lower punch setscrew”, “follower bolt” and “pinion holder” and rotate “adjusting pinion” to make “lower punch” down and take it out of the bottom hole of “body”.
Assembly: conduct inreverse order as above.


4. Pulley, pinion and pinion shaft

Disassembly: disassemble V-belt, screw nut and washer at the right end of “pinion shaft” off (before which disassemble press plate after body), firmly grasp “pulley” with “pinion shaft” form the “body”, and then withdraw “pinion shaft” form “pinion shaft” hole, integrate “pulley” and “pinion” (and TDP-5 “pinion copper bushing”). Never to disassemble unless beat “pinion” from “pulley” hole with copper bar.
Assembly: conduct in reverse order as above.


5.Main shaft

Disassembly
TDP-1.5: A. Disassemble “gearwheel shield”, “pulley” and “gearwheel” inside with wooden hammer, and disassemble “gearwheel”; B. Disassemble “tapered gland” and “handwheel”; C. Disassemble “feeding rod” and “feeding cam” (Don’t let “lifting roller” miss); D. Loosen “lifting cam”, “eccentric wheel” and setscrew; E. Loosen “pitman pin” set bolt and fetch “pitman pin”; F. Beat gearwheel shaft with wooden hammer and copper bar (Don’t damage threaded hole at shaft end), and firmly grasp the other end of “main shaft” and “lifting cam” and “eccentric wheel sleeve”, and fetch “main shaft” from “body” hole.

TDP-5: A. Disassemble “gearwheel shield”, “pulley” and “gearwheel gland”, beat non-working surface inside “gearwheel” with wooden hammer, and disassemble “gearwheel”; B. disassemble “tapered gland” and “handwheel”; C. Disassemble “feeding rod” and “feeding cam” (Don’t let lifting roller miss); D. Loosen “pitman pin” set bolt and fetch “pitman pin” E. Beat gearwheel shaft end with wooden hammer and copper bar (Don’t damage threaded hole at shaft end), and firmly grasp the other end of “main shaft” and “eccentric wheel sleeve”, and fetch “main shaft” from “body” hole.
Assembly: conduct in reverse order as above.

More tablet press pill dies for you with custom orders.