Home > Help Center > FAQ
Assembly and Commissioning of Tablet Press
1. The tablet press should be installed in the secure wooden workbench with three pairs of M12 foot screws. The height of workbench above floor is of approximately 600mm (hand-operated for convenience).

A hole of approximate 35mm diameter should be reserved in the lower punch mandrel of the wooden workbench for comfortable disassembly and repair in future.


2. Securely ensure motor well-connected with ground wire prior to power-on. Disassembling V-belt, turn on the current to start motor and observe whether motor is rotating in a correct direction (the direction in which motor shaft rotates should be the same as the arrow direction on the gearwheel shield.) If its direction of rotation is incorrect, the other wire will connect, assembling V-belt.


Buy Tablet Press Machine with our best service.